有的交流双束电梯采用继电器控制,器件多,控制结构复杂,接触式触点可靠性差。交流调速电梯早期大多数是分立元件控制。许多原器件,例如可控硅的原器件,当时的技术不好,制造质量不稳定。当时制造的直流电的调速电梯基本上是发电机拖动,使用噪音大。机械式选层器由于磨擦,容易导致触头磨损而出现接触不良。分立元件在继电器的控制下,故障率很高。
有的交流双束电梯采用继电器控制,器件多,控制结构复杂,接触式触点可靠性差。
Some interchange twin bunchs of elevators and adopt the RC , and the component are much , and the control structure is complex , and the contact style tip dependability is bad 。
交流调速电梯早期大多数是分立元件控制。
The exchange shifts the rapid elevator early phase bulk are that the discrete component is dominateeed 。
许多原器件,例如可控硅的原器件,当时的技术不好,制造质量不稳定。
Much original component ,For instance original component of silicon controlled rectifier ,The technique at that time is not good ,The tabrication quality is not steadyd 。
当时制造的直流电的调速电梯基本上是发电机拖动,使用噪音大。
The rapid elevator of the direct current manufacture at that time accent is that the dynamo drags haul essentially ,The use noise is greatly 。
机械式选层器由于磨擦,容易导致触头磨损而出现接触不良。
The mechanical type chooses the tier utensil thanks to the rub ,Cause easily the contact finger to wear and tear and has ariseed loose contact 。
分立元件在继电器的控制下,故障率很高
The discrete component is living , and relay control is geted off ,Therefore block leading is very tall
。
。